is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Install Concrete Curbing Along Sidewalks
1 Concrete mixer
2 Wheelbarrow
3 Shovel
4 Trowel
5 Concrete edger
6 Concrete float
7 Rubber mallet
8 Tape measure
9 Level
10 Safety glasses
11 Work gloves
12 Knee pads
13 Concrete saw
14 Hammer drill
15 Masonry drill bit.

How to Install Concrete Curbing Along Sidewalks

Step-by-Step Guide to Installing Concrete Curbing Along Sidewalks

Installing concrete curbing along sidewalks is a great way to enhance the look of your property, while also providing a functional boundary between your lawn and the sidewalk. While it may seem like a daunting task, with the right tools and techniques, it can be completed relatively easily. Here are the steps to follow when installing concrete curbing along sidewalks:

1. Plan the project: Before starting the installation, take the time to plan out the project. Determine the length of the curbing needed, as well as any curves or turns that will need to be made. Mark the area with spray paint or stakes to ensure accuracy.

2. Prepare the area: Clear the area of any debris or vegetation that may interfere with the installation. Use a shovel or edger to create a trench along the sidewalk where the curbing will be installed. The trench should be approximately 6 inches wide and 4 inches deep.

3. Mix the concrete: Follow the manufacturer's instructions to mix the concrete. It should be a thick consistency, similar to oatmeal. If the mixture is too thin, it will not hold its shape. If it is too thick, it will be difficult to work with.

4. Install the forms: Place the curbing forms along the trench, ensuring they are level and secure. The forms should be slightly higher than the final height of the curbing, to allow for settling.

5. Pour the concrete: Use a shovel or trowel to fill the forms with the concrete mixture. Work the mixture into the corners and edges, ensuring there are no gaps or air pockets. Smooth the top of the curbing with a trowel.

6. Finishing touches: Once the concrete has set for a few hours, remove the forms. Use a trowel or edger to smooth the edges of the curbing. If desired, add a decorative finish to the top of the curbing.

7. Allow to cure: Allow the concrete to cure for at least 24 hours before walking on it. It will take several days for the concrete to fully cure and harden.

By following these steps, you can install concrete curbing along sidewalks to enhance the look of your property and provide a functional boundary between your lawn and the sidewalk.